Sax on the Web Forum banner

1 - 4 of 4 Posts

·
Banned
Joined
·
2,844 Posts
Discussion Starter #1
Can a neck tenon that is 27.8mm be shrunk down to 27.5mm?

I just need the question answered by someone that really knows. Is that too much? I don't need the warnings about this or that, or the take it to a qualified tech blah blah blah. Thanks.
 

·
Distinguished Technician & SOTW Columnist. RIP, Yo
Joined
·
17,204 Posts
I think that is viable, providing the technician has appropriate gear.
If it is not viable using shrinking tools, then it could quite easily be done on a lathe (with an appropriate holding tool - an appropriate finger-type expanding tool should do just fine.)
 

·
Distinguished SOTW Coffee Guru
Joined
·
38,885 Posts
1 - 4 of 4 Posts
Top