[muddee16]

I just ordered some ligs to try out from WWBW, and was very excited to check out the Selmer 402. I have a tenor LT Guardala mpc, and I ordered the lig for alto, as I thought that would be the correct size. But to my disappointment, when I put the lig on, it was just barley too small Should I have ordered the tenor version? Any advice would be much appreciated!

 

[fusion1]

Start reading post #89 in this thread

http://forum.saxontheweb.net/showthread.php?139466-Guardala-Studio/page5

Basically take off the blue tape, and use a thinner reed like a Rico. Cinch the screws tight and then push it further back making it tighter, and then further tightening the screws over time. This will mold the metal around the piece better.