Sax on the Web Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
104 Posts
Discussion Starter · #1 ·
Hello

I have a Weltklang Tenor which came with an old brown Selmer S80 C* MPC, with a bore of 16.85mm. This fits tightly on the neck of the Weltklang. I also have a Yamaha 4C MPC which I used on my YTS 62, and this has a bore of 17mm, and so very loose on the neck of the Weltklang

Looking at old posts, I see that this is a pet peeve of many people in that there is no standard size.

I want to try a new MPC (not sure what I will be looking for, but will take it in and try a few). My worry is that maybe the cork on the Weltklang will be too loose for the all the new or old MPC's, so would I be better off recorking it and sanding it to fit the Yamaha 4C on it until I find the right MPC, or should I leave it as it is, and wrap paper around the neck when I check the MPC's. Once I decide on an MPC, I would know whether and how to recork it

Any advice?

Regards
Dave
 

·
Registered
Joined
·
104 Posts
Discussion Starter · #3 ·
Thanks for the advice

OK, my Yamaha 4c seems to fit several other saxes, including the recorked neck of my (under construction) dolnet series 2
So what I will do is recork the neck of the weltklang so that my 4c fits it, and then enlarge the bore on the selmer s80 to fit that

I will then go to the sax shop and see what other MPCs I like.
 
1 - 2 of 2 Posts
Top