Sax on the Web Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
274 Posts
Discussion Starter #1
Anybody have pad sizes for a King 660 alto (made in USA from the 90's, rolled tone holes, high F#, "K" bell/body brace...)? I'd rather not take it all apart just to measure, but will if I have to. Thanks!
 

·
Registered
Joined
·
489 Posts
I thought that was a UPI manufactured horn. I didn't think they came with rolled tone holes. You might just have to measure 'em yourself :mad:
 

·
Distinguished SOTW Member, Forum Contributor 2016
Joined
·
17,948 Posts
You'd be best to take it apart and measure...although perhaps you can cross-reference with Ferree's or Allied parts supply and see if they have a standard table which includes this horn. They may...or may not.

If it's really a '90's horn then the cup sizes should certainly be standardized enough that a source/chart would be a safe bet.

But all of that may take longer than actually just measuring the pads yourself...
 
1 - 4 of 4 Posts
Top