Sax on the Web Forum banner

10mfan Rubusto HR vs 3D size

554 Views 3 Replies 2 Participants Last post by  10mfan
Anyway who has had both the original 3D-printed and the Gen 1 hard rubber, are they the same size? I have a 3D which I like but never tried the HR. I tried a metal which had a much smaller profile (as expected) but didn't care for it as much. Email or PM reply is fine too.

Tried to correct the spelling of Robusto but I am not allow to do that if it is in the thread title. Sigh.
1 - 2 of 4 Posts
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.