Sax on the Web Forum banner
Cancel

Search Results for ‘neck extension’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

10mfan advice altissimo alto alto saxophone alto saxophone mouthpiece artem zhulyev bari baritone baritone saxophone barone bass clarinet beginner berg berg larsen blues brilhart buescher buffet cannonball case clarinet classical conn conn 10m curved soprano custom dave pollack doubling drake dukoff early babbitt ebay embouchure florida flute for sale / for trade funk guardala hard rubber help needed improvisation intonation jazz jody jazz keilwerth king lawton lebayle ligature link mark vi metal meyer morgan mouthpiece mpc music neck otto link practice quartet rafael navarro recording reed reeds repair rico sale sax saxophone sba selmer selmer mark vi sheet music silver slant sml - strasser marigaux solo soloist soprano soprano mouthpiece soprano saxophone stm ted klum tenor tenor mouthpiece tenor sax tenor sax mouthpiece tenor saxophone the martin theo wanne tone trade transcription vandoren vintage wanted yamaha yanagisawa
  1. Necks
    My 1936 10M with its original neck is approximately 11-1/4 inches in length. I can get the horn to play in tune, but barely, by pulling off the mouthpiece leaving only about 1/2 inch of cork under the piece. Reducing the wobble is accomplished with a sheet of ordinary Sticky-Notes paper from the...
    10m custom neck gloger neck extension neck needed
  2. Eb Baritone
    Dimensions of my neck cork and my metal Link O.D. Cork - 11/16 I.D. Link - 11/16 O.D. Link - 25/32 (3/4 + 1/32) Found on Amazon.com $ 1.15 Nylon 101 Hollow Bushing Stock 3/4" Nominal OD X 11/16" Nominal ID 12" Length $ 8.03 Polycarbonate Tubing, 3/4" ID x 1" OD x 1/8" Wall...
    conn conn baritone vintage neck extension
1-2 of 2 Results
Top